| Info |
|---|
The Show mode program is a option function of the official Pally URCap (release 2.12 and above). To access it, you will require a DEMO or Trial license. If you already have one of these licenses, under “Installation-URCaps-Pally-Advanced-Other”, select “Show mode” in the Operation Mode drop-down menu. The Show mode program was made to show the different functionalities of Pally. It will depalletize from one pallet, drop the boxes off on the conveyor/drop-off position and then palletize them on the other pallet. |
| Info |
|---|
If you can’t find “Show mode” try to restart Polyscope. |
Setup requirements:
For the Show mode program to work, the following is required;
...
After enabling “Demo”-mode, set up Pally as usual. If you doubt, visit the link: Get started - Pally URCap.
Please note that the Show mode program requires both Primary and Secondary conveyor enabled and to be configured/calibrated correctly. Conveyor width, Fixed guide position and width should be the same on both conveyors.
...