Dual Product Mode

With Pally you can palletize two different products from two different conveyor at the same time.

Follow these steps to set up Dual Product Mode.

1. Enable Secondary conveyor and calibrate the pickup position

   

2. Add product sensors for the second conveyor

   

3. Check off Dual Product Mode under Advanced and System tab

   

You have now activated Dual Product Mode in Pally and is ready to start palletizing. See example below to start palletizing different products.

Note: l1 is the primary pickup position and l2 is the second pickup position

Note: Boxes from the left conveyor goes to the left pallet. Boxes from the right conveyor goes to the right pallet

Note: When using a lifting column in dual product mode, the dynamic positioning option must be selected in order to ensure that the lifting column is always in the optimal position.

Example project:

Palletizing from two conveyors with two different products

Pattern on the right pallet: box1.json

Pattern on the left pallet: box2.json

Press Play on the robot and a popup box appear. This is the pattern selector for Dual Product Mode

Type in l1_box1 and press Submit

Select Yes on Dual Product Mode

Type in l2_box2 to address box2 to the left pallet, and press Submit

Palletizing will now begin.

If you stop and start the robot during palletizing you get several options:

a: Continue where you left the palletizing prosess

n: Clear the palletizing prosess and start over

1: Continue only right pallet

2: Continue only left pallet

Select one of the alternatives and press Submit