Content Comparison

...

• Only one side moves

• Not leaving enough room for gripper

• Vertical exit needed

• TCP issues

Setting up the pattern

To create the pattern, it is suggested to use an inverted approach. (see picture below) This enables Pally to begin working from the side closest to the robot and move outwards, ensuring that the gripper always has enough space to open.

...

You can also use the “Customize box index” to arrange the boxes the way you want them, to ensure you always have free space to open the pich gripper. See picture below

...

To prevent collisions, it is suggested to lock the box rotations. (see picture below) This will ensure it is always placed in the same positions. You should see only one arrow on the top of each box.

...

Vertical Exit

Vertical exit is also needed when using a Pinch gripper.

Vertical exit is the default setting in Pally, and the total length of the vertical motion can be controlled by the parameter rf_foam_height (also works for pinch grippers).

Just add the following code in the initial MoveJ StartPosition (example):

rf_foam_height = 0.18

Vertical exit is active only if bit 2 is set in the rf_release_strategy variable. Read more about release strategy here - Release Strategy

Just add the following code in the initial MoveJ StartPosition (example):

rf_release_strategy = 6

TCP issues

Pinch grippers are configured like other custom grippers by adding the length, width, height and weight. It's keep in mind that the TCP is configured correctly. Sometimes, when only one side moves, it may be necessary to change the TCP from one product to another. This can be easily accomplished by using an If statement at the beginning of the program to check which pattern is being used.
Gripper and TCP check .

In the following example, the TCP X-offset is the distance from the tool flange to the box center point. TCP Z-offset is the distance from the tool flange to the top of the box.

The clamp offset refers to the distance between the tool flange and the fixed clamp.

When picking, it might be necessary to keep a small distance between the fixed clamp and the box. The push offset indicates this distance.

Image Added

The following sample code is provided for reference.

Example picture of code:

...

Vertical exit is also needed when using a Pinch gripper. This can easily be added to the program by adding the following code to the initial moveJ. Change Release strategy to 2 will allow Pally to use vertical exits.

rf_release_strategy= 2

...

Important steps:

• include the script “PinchGripperTools” in the initial MoveJ node under the Pally node

• set rf_gripper_align_to_edges = False

• set rf_foam_height=ProductHeight in the onNextTask callback

• call ApplyTCP() in beforePallet and beforeZone

• call CustomMoveBeforeGrab() in the beforeGrab callback (apply push offset)

• call CustomMoveAfterGrab() in the afterGrab callback (lift up vertically)

See also Gripper and TCP check