...
Production line name
The conveyor could can be named to be displayed on in the Pally Operator Panel. Naming the conveyor has the best use case when palletizing from two conveyors.
...
Before naming the conveyor
...
After naming the conveyor
Robot position
Calibrate the pickup position
After placing the calibration box at on the end of the conveyor, Calibrate calibrate the pickup position by moving the robot over the box with the gripper perfectly in the center of the box.
...
Type in the total width of the conveyor. This should include everything that the robot, gripper or the box could collide into.
| Info |
|---|
Press the question mark (?) to see more information |
...
Fixed guide position
Fixed guide position is that side of the conveyor that is stationary or not adjustable.
| Info |
|---|
The left or right side is defined by standing at the end of the conveyor and looking upwards at the conveyor. |
Fixed guide width
Measure the fixed guide width and other . This could also include objects that the robot could collide into.
...